FILTER ELEMENT CLEANING INSTRUCTIONS

CLEAN BY COMPRESSED AIR

• Using approximately 100 PSI, direct air flow at inside of element towards pleats.
  

• Blow off the outside of the element directing the air flow down to avoid embedding dirt in the media.
  

• Blow off the inside again to remove any dirt that might be on the clean side of the element.
  

• The element is ready to be re-used.
  

CLEAN BY HAND WASHING

• Soak and agitate element in a warm water & mild detergent solution.
  

• Allow adequate time for the element to air dry. (12 hours minimum)
  

• Do not install a damp element.  This will cause higher initial pressure loss & rapid dirt loading.
  

• The dry element is ready to be re-used.
  

800-423-7947

*RETURN HOME*

• Remove element from housing.
  

• Hold element down with one hand & move other hand across the fins in a strumming motion.  This action will dislodge most of the dirt.
  

• The element is ready to be re-used.
  

CLEANING BY VACUUM

• Remove element from housing.
  

• Vacuum from dirty side only, using a vacuum of approximately 40" w.c.
  

• A crevice attachment is recommended.
  

• The element is ready to be re-used.
  

CLEANING BY HAND